The process of installing an LED display board does not have to be challenging. Whether you are an AV integrator, event producer, or system designer, this guide will provide you with an insight into the fundamentals of the process. You’ll learn how to connect hardware, operate software, and adjust your display so it performs well and looks great every time.
Step 1: Hardware Connections Configuration
Start by joining all components properly.
- Control System Wiring: Insert the sending card in your PC and connect receiving cards to the LED panels.
- Signal chain: Connect data cables (CAT5/CAT6) between one panel to another consecutively.
- Network configuration: Assign different IP addresses to different controllers to prevent a conflict.
Check out JYLED’s LED control cards for supported models and wiring tips. This will make your setup stable initially.
Step 2: Control Software Setup
Next, install the software that came with your LED system, e.g. NovaStar.
Launch the software and input the hardware configuration of your display such as display size, layout and card details. Ensure that you have the latest firmware. If you have a setup wizard use that, it will walk you through the process.
Get help at the JYLED support page or visit NovaStar in case you are stuck or require download links.
Step 3: Display Mapping & Calibration
This action gives your screen an aligned and sharp appearance.
- Module mapping: Detect the panel layout using the software.
- Module Seam Correction: Repair visible lines by modifying the borders of panels.
- Brightness & Uniformity Calibration: Display test patterns and adjust brightness to make all things appear even.
JYLED screens have built-in features that will assist you in this and to get additional assistance on calibration settings.
Step 4: Configuring Video Input & Output Parameters
- Selecting Input Source (HDMI, DVI, SDI) in Software: Choose your input source in your software, depending on what your system supports, HDMI, DVI, or SDI.
- Setting Output Resolution, refresh rate, and timing: Next, adjust the output resolution to the size of the pixel of your LED display. Select appropriate refresh rate and timing to eliminate flicker or delay.
- Cropping/Scaling settings, aspect ratio, deinterlacing: With the help of cropping and scaling tools, adjust the video to fit your screen, and change the aspect ratio or use deinterlacing (in case needed).
To learn how to select the appropriate processor, see JYLED articles or go to AVPro Edge.
Step 5: Testing, Previewing & Troubleshooting
- Preview mode & signal monitoring via software GUI: Browse the preview option in your software to monitor the signal and arrangement of your display.
- Common errors: The most common ones to look out for are a blank screen, flickering and misaligned panels.
- Fixes: In case you identify any problems, possible solutions are to recheck your cables, re-map your display, or reload your settings.
Still need assistance? Check out JYLED troubleshooting page to get quick assistance.
Step 6: Saving, Backup & Networking
It is better to save your setup to avoid losing your work.
- Saving configuration to both board and software: Save settings to both your PC and the LED board.
- Backing up profiles for future recall or emergency recovery: Make backup files just in case you may require restoring them in the future.
- Enabling remote management via LAN/Wi‑Fi: Control the display remotely by using LAN or Wi-Fi.
For advanced setups, JYLED provides remote display solution which allows you to control screens even when you are not on-site.
Conclusion
You have learned how to set up your LED display board, including wiring and testing. All the steps are easy to set up. Make it easier with the tools and guides offered by JYLED. Contact JYLED to get more resources and make your setup hassle-free!
